Rigid pod

[Leonidas]

This little plastic trim piece that wiggles around seems like a good candidate to remove and modify to house a Rigid light…

 

[AXE]

This little plastic trim piece that wiggles around seems like a good candidate to remove and modify to house a Rigid light…

I've pulled mine off to reseat it cause it was loose. It's attached with normal body clips like in the fuse panel cover.

It's got a plastic housing behind it that I think supports the headlight. Not sure if you can modify that or not.

 

[amateurhour]

Almost every time I walk in front of the truck I ponder how I could do something like this! It seems like a good project for someone with a 3D printer…I wonder if the wife would notice if one appeared in the garage

 

[ZR2BIZON]

@amateurhour so far I've ordered a 3d printer a laser cutter and the winch "accidentally"
Working on ordering a cnc accidentally too but she's on to me now lol

 

[sardarjee]

@amateurhour so far I've ordered a 3d printer a laser cutter and the winch "accidentally"
Working on ordering a cnc accidentally too but she's on to me now lol

Hope you also disclosed that there is "No Return Policy"

 

[AXE]

Also, if you pull the wheel well liner you can see what's behind there. I recall it might still be a bit of a CF behind there too.

I pulled wheel well liner cause that trim piece was hard to get back in place as the clips seem a little short for the attachment points.

 

[Leonidas]

Also, if you pull the wheel well liner you can see what's behind there. I recall it might still be a bit of a CF behind there too.

I pulled wheel well liner cause that trim piece was hard to get back in place as the clips seem a little short for the attachment points.

Ya, it doesn’t seem right for them to be so loose…

 

[AXE]

My drivers side is still really loose. They ordered new ones back in January. Only one had come in, then the body shop has to paint them.

I should just toss them and do the lights like you've shown.